How to make bright floors in the living room

Introduction:

Today we have a new addition to the profession of finishing flooring, which is to make an illuminated ground décor amidst the ceramic floor to decorate the living room

Illuminated floor with hand strips around a beautiful stone and covered with a reinforced glass panel or a translucent acrylic palette,

A beautiful idea added to the profession of ground interior finishes, can be implemented with ease and creativity to impart the inner beauty of the house

Step 1 : Materials and tools

Materials

Glass Panel or transparent acrylic (here we will work on an area of 1.5 m * 3.00 m in a rectangular form)
A bar of white double led bulbs

Small stones of beach stones

Ceramic Flooring

Concrete mix

Tools
 Adhesive (silicone)

Ceramic Scissors

 


Step 2 : Taking the necessary measurements and installing electricity wires

Install the ceramic floor to the entire room with a precise determination of the place of the illuminated floor, when arriving at the specified place of work leave it empty without placing the ceramic on the floor, connect the electrical wires to the work area, to control the lighting and extinguish the lights of the floor as desired

Power wires pass from the bottom of the high floor of the room until you reach the work area
As shown in the picture


Step 3 : Low Ceramic installation

Reduce the floor level of the ceramic floor surface by 5 cm and complete the installation of ceramics, as in the form
Then cut the longitudinal pieces of ceramic with a width of 4 cm to be fitted in the sides of the floor between the normal and low ground on a current
Note that there are 1 cm difference between the two floors which is the cm of the glass panel

The rectangle in the middle is lower than the normal floor level of the entire room by 1 cm


Step 4 : hand strips

After finishing the installation of low ceramics and shaping the work in all details

Paste the hand lights on the interior of the floor and the center rectangle with a width of 4 cm,
test the connection of electricity and lighting to make sure the good work for the lighting

and the formation of small stones

put the small stones in the places allocated to them in front of the lighting to reflect The beauty of lighting on it when running

You can choose different types, sizes and colors of the stones to use,
draw the shape you loved in the position of the stones and overlap their colors on the floor

 


Step 5 : The formation of small stones

put the small stones in the places allocated to them in front of the lighting to reflect The beauty of lighting on it when running

You can choose different types, sizes and colors of the stones to use
draw the shape you loved in the position of the stones and overlap their colors on the floor


Step 6 : Put the glass panel

bring the glass plate 1 cm thick, and put it over the low area

Cover the stones and the center area of the glass panel, and then put the silicon between the board and the ceramic

Put the silicone well and more accurately so that the water does not get inside when used to clean the floor


Step 7 : Test and finish

After placing the silicone, check the work well to make sure all the spaces between the ceramic and the glass board are blocked, so that the water does not leak into the illuminated floor and containing electricity

,After a good check
enjoy it in the living room with a high beauty and elegance

Comments

  • Leave a Comment

    Please Sign in to Post comments


Prev Next

Facebook Google+ Twitter Addthis